Hydraulic Edge of Dock Leveler
EDH Series
Description
Hydraulic Edge of Dock Levelers raise and lower automatically at the push of a button, bridging the gap between the shipping dock and the delivery truck / trailer. They provide a 5″ service range from dock height.
Details
- Fully Hydraulic operation – No pulling or lifting required
- No back injuries or mashed fingers from handling portable dock boards
- Returns to stored position when truck departs
Product Features
- Heavy Duty Construction
- Deck and Lip are 3/8″ thick 55,000 lb. minimum yield steel tread plate
- Full width hinge tubing and pin provide total load distribution
- Rugged steel bump blocks with structural center support provide maximum impact resistance
- No special tools required – Lubricated hinge tubing
- 110v/1ph/1hp/60Hz, Self-contained Power-pack
- Service Range: +/- 5″ from dock height
- Capacities: 20,000 / 25,000 / 30,000 lbs.
- Available Widths: 66″, 72″, 78″ and 84″
Overall Dimensions |
|
|
Steel Dock Edge Facing (Embedded Channel)
|
Side View – Operating Range
|
| Model | A | B |
| EDH66xx | 66″ | 96″ |
| EDH72xx | 72″ | 102″ |
| EDH78xx | 78″ | 108″ |
| EDH84xx | 84″ | 114″ |
| NOTE: A Flat plate unit is recommended for below dock or steep decline (consult factory). For Model number, add ‘F’ suffix. | To help you determine the most effective and best suited installation for your particular conditions, our engineers will evaluate your operation and submit complete recommendations and cost estimates. |
Product Options
- 220v-460v/3ph/1hp/60Hz, Self-contained Power-pack
- 17″ Lip – Recommended for use with refrigerated trailers
- Flat plates: Recommended for use with pallet jacks, specialty carts or forklift applications where forks will be on or near the floor during operation
- Installation accessories: Approach plates, formed angles
- Steel face plate on bumper
- USPS (US Post Office) Specified Units: Equipped with 2″ Cart Guard
| Model | A | B |
|---|---|---|
| EDH66xx | 66″ | 96″ |
| EDH72xx | 72″ | 102″ |
| EDH78xx | 78″ | 108″ |
| EDH84xx | 84″ | 114″ |
Accessories
There are no accessories listed for this product.
Instructions
Fully automatic with recycle feature. Remove end load, if any, form truck while unit is in stored position. Raise unit to vertical position by activating control. Release control and leveler will lower to truck. When truck pulls away unit will return to stored position. Note: To recycle leveler with truck in position simply activate control until lip section contracts and is clear of truck then release control unit will store automatically.